CMSIS-DAP Cat Programmer
An Open-Source CMSIS-DAP Debug Probe based on DAPLink
Description
DAP Cat Programmer is a low-cost of $3 dollars debug probe based on the CMSIS-DAP (also known as DAPLink) protocol standard and USB-Serial convert and it can realize USB convert to serial interface. It can be used to program and debug the application software running on Arm Cortex Microcontrollers.
The probe comes with indicator LEDs, a button to reset the target or trigger the firmware update, reversible USB-C connector and easy-to-use 10-pin 2.54mm Header.
Features
- CH552G microcontroller
- 16KB Flash, 1KB xRAM & 256B iRAM;
- ROM-based USB drivers. Flash updates via USB supported.
- Shipped with Arm Mbed DAPLink Firmware
- HID - CMSIS-DAP compliant debug channel
- USB Serial bus convert and it can realize USB convert to serial interface.
- Supported Arduino IDE and OpenOCD
- LED indicator & Button
- 3.3V DC-DC regulator with 1A output current
- 3.3V Digital I/O Operating Voltage
- Reversible USB-C Connector
- Easy-to-use 5-pin 2.54mm Header with SWD & UART interface
- Very small form factor: 20 x 48 mm
Software compatible
Tested
- OpenOCD
- Arduino IDE
- Keil
- PyOCD()
Without Test
- Dap.js()
- IAR
- edbg
Manual available
Driver for windows
Zadig is the recommended tool to install drivers in Windows. The bootloader (4348,55E0) should be installed with WinUSB or libusb-win32 driver.
You can use USB Serial (CDC) driver for default CDC USB stack. If you tried to emulate another type of USB device without changing the PID/VID, you may need to uninstall the device before installing a new driver.
Special Thanks
- Deqing Sun
- CH552 Group in Telegram
License
LGPL
Electronic Cats invests time and resources providing this open source design, please support Electronic Cats and open-source hardware by purchasing products from Electronic Cats!
Designed by Electronic Cats.
Firmware released under an GNU LGPL v3.0 license. See the LICENSE file for more information.
Hardware released under an CERN Open Hardware Licence v1.2. See the LICENSE_HARDWARE file for more information.
Electronic Cats is a registered trademark, please do not use if you sell these PCBs.
29 Agu 2020