NewRemoteSwitch library v1.2.0 (20140128) for Arduino 1.0 Made by Randy Simons http://randysimons.nl/
This library provides an easy class for Arduino, to send and receive signals used by some common "new style" 433MHz remote control switches.
There are two styles of remote:
- "old style", which uses switches or a dial to set the house code. Use the RemoteSwitch library instead.
- "new style", which use a button on the receivers to "learn" a signal. Use this library.
License: GPLv3. See ./NewRemoteSwitch/license.txt
Latest source and wiki: https://bitbucket.org/fuzzillogic/433mhzforarduino
Installation of library:
- Make sure Arduino is closed
- Copy the directory NewRemoteSwitch to the Arduino library directory (usually /libraries/) See http://arduino.cc/en/Guide/Libraries for detailed instructions.
Default installation demo:
- Connect the data-out-pin of a 433MHz receiver to digital pin 2. See photo. (Note: your hardware may have a different pin configuration!)
- Start Arduino, and open the example: File -> Examples -> NewRemoteSwitch -> ShowReceivedCode or ShowReceivedCodeNewRemote.
- Compile, upload and run
- Open serial monitor in Arduino (115200 baud)
- Press buttons on a 433MHz-remote, and watch the serial monitor
Changelog: NewRemoteSwitch library v1.2.0 (20140128) for Arduino 1.0
- Revisited receiving dim-levels. Now it is always optional, check dimLevelPresent to see if it was transmitted. This change might break your code, as SwitchType::on_with_dim is removed.
- Added NewRemoteTransmitter::sendGroupDim.
- Added Dimmer example. Thanks to a Bitcoin donation, I could actually test it!
NewRemoteSwitch library v1.1.0 (20130601) for Arduino 1.0
- BUGFIX: in many occasions, when receiving a dim-level, the code was rejected even if the signal was correct.
- Support decoding A-series transmitters which transmit a dim-level in combination with an on-signal, instead of a dim-signal.
- Uses NewRemodeCode::on, ::off, ::dim, ::on_with_dim instead of 0, 1, 2 and 3, for better readability. This change is backwards compatible.
- Updated examples to use the new NewRemodeCode::on, ::off, ::dim and ::on_with_dim notation.
- Reduced memory usage (Flash, RAM)
NewRemoteSwitch library v1.0.0 (20121229) for Arduino 1.0
- Support for receiving A-series Klik-aan-klik-uit remote. (NewRemoteReceiver)
- With examples to test and demonstrate.